Let the controller completely discharge before plugging it back in to recharge. There are a few things you can do to prolong the lifetime of the battery: We are not at the technological stage where rechargeable batteries last forever. What can I do to prevent this from happening? Eventually, the battery will only give you a few seconds of life, before completely cutting out. At first, the battery may only last half the time it did when the controller was brand new. Rechargeable batteries don't last forever, and multiple causes can lead to a lower battery life. It sounds like your already naturally doing this however, you could also be at the end of the battery lifetime. The immediate solution is to plug it in and let it charge. This seems like an obvious answer, but working in technical support, I can tell you that even we miss the little things from time to time. To test this out, try the controller on a PlayStation 4 console, and see if it still shuts down after 5 seconds. The LED on the remote will tell you what number each remote has been assigned, so if you sync more than one, they should be assigned sequentially, 1, 2, 3, 4 etc.The internal battery may be dead. When you have paired one remote, you need to move quickly on to the next before the sync window times out. Don’t repeat Steps 1 and 2 for extra remotes otherwise you reset everything again!Ī quick note about pairing multiple Wii remotes. You will then need to repeat Steps 3 and 4 for other Wii remotes you need to pair. Step 2 clears the initial pairing and the following steps sets up your remotes as a new pair. This simple pairing process first clears any paired remotes and then re-pairs them. 
Repeat Steps 3 and 4 for the other remote(s).
Press the Sync button on the Wii console again and wait for the two to pair.Remove the battery cover from your Wii remote and press the red Sync button there.When you see the Health & Safety warning, open the SD card slot on the front of the console and press and hold the red Sync button for around 15 seconds.Power off your Wii and power it on again.It’s a simple process that takes less than two minutes. Resync your remotesĪs the Wii remotes are wireless, Nintendo built in a way to re-sync them should they lose connection with the console. If they connect normally, there is no need to continue. Turn it off at the mains, leave it for 30 seconds, then turn it on again and see if it picks up your Wii remotes. It works on phones, on computers and on most consumer devices and it could work here.
0 kommentar(er)
